HP Pro Shredder 15CC Mode D'emploi page 17

Emptying the Waste Bin
Check the fill level of the waste bin through the viewing window at regular intervals and when it
is about 80% full, empty it. This prevents the shredded material from accumulating, which could
lead to malfunctions.
1 Switch the device off by pressing the On/Off button.
2 Disconnect the power plug from the power socket.
3 Pull the waste bin out of the device.
4 Empty the waste bin.
5 Slide the waste bin in the device.
Î The waste bin latches audibly in place.
Clearing Residual Material
If the shredder no longer shreds material as you expect, remove any residual material from the
cutting mechanism.
1 Press and hold the REV button.The cutting mechanism runs in reverse and releases any mate-
rial remaining in the cutting mechanism.
2 Release the REV button.
3 Switch the device off by pressing the On/Off button.
4 Disconnect the power plug from the power socket.
Caution!
Risk of injury through sharp edge of cutting mechanism! Take the utmost care
when removing the material residue.
5
Remove the residual material carefully from the cutting mechanism using an appropriate
pointed object.
Cleaning the Shredder
Clean the shredder at regular intervals.
Caution!
Risk of injury through flash flame! Such flash flames can occur when using air
sprays. Never use air sprays.
1 Switch the device off by pressing the On/Off button.
2 Disconnect the power plug from the power socket.
3 Clean the surface of the housing with a soft, dry, lint-free cloth. Do not use any aerosols,
solvents or cleaning agents.
- 17 -
EN