Publicité
Les langues disponibles
Les langues disponibles
10
Installation detail of a bead liner with top track.
Hang the liner on the top of the wall and install the top track to se-
cure.
RESIN TOP
TRACK
U-BEAD
LINER
WALL
Start the vacuum cleaner to allow the liner to adhere to the wall and
check for excess tension at the bottom or for wrinkles. Adjust the
liner by removing wrinkles if needed, lift or lower it in order to ensure
a perfect fit.
11
UPRIGHT POST INSTALLATION (round section)
For the round section:
Attach the uprights to the bottom plate with two (2) screws "Z",
which you will find in the hardware bag.
Uprights must be installed inside the flanged part of the bottom plate
and into the two notchs of the bottom track.
12
Put the top plate on the upper side of the upright, and secure with
two (2) screws "Z" on each side.
VINYL LINER INSTALLATION (continued)
STEEL
TOP TRACK
UPRIGHT POST TOP PLATE (round section)
Fill the pool with water up to the base of the wall before stopping
and removing the vacuum cleaner.
PUMP RETURN FITTING
After you remove the vacuum cleaner, you may install the return fit-
ting. Place the return fitting ring against the liner and adjust it so
that it is perfectly aligned with the hole in the wall. When the ring is
properly positioned and secured, cut the liner in the middle of the
ring.
Insert the return fitting from the inside, placing the first gasket be-
tween the return fitting and the liner and the second between the
wall and the liner. Then tighten the outside ring with large pliers, tak-
ing care not to crease the liner.
BOTTOM DRAIN (optional)
Find the holes through the middle of the liner and screw the ring
and gasket in against the liner before cutting the liner in the middle
of the ring, then screw on the drain cover.
SCREW ''Z''
BOTTOM
PLATE
TOP
PLATE
SCREW ''Z''
UPRIGHT
Publicité
