8
Add sand.
Choose the filter location beside a round section (never in a straight
section). The starting point should be at that location where the
skimmer and return holes are, and as close as possible to the fil-
tration system. When installing the steel wall, it is important to
do so in a location protected from the wind or on a day without
any wind.
Before uncoiling the wall, make sure the pre-punched holes for the
skimmer and pump return are at the top and facing the planned lo-
SAND
Begin inserting the wall into the bottom tracks in the middle of a
bottom plate. At first, the wall is kept in place with one or two stakes
and strings (or extra persons). One person uncoils the wall on a
beam or a plank, while a second person inserts it in the bottom
tracks. Do not uncoil more than 3 m (10') of wall before you install
a support bar or stake and string to reinforce the structure.
Once the wall is completely uncoiled, you may find that it is too
long or that both ends do not meet by a few centimetres. If such is
the case, adjust tracks and bottom plates until wall holes line up. If
this does not work, roll up the wall again, check measurements as
per Illustrition 1.1, adjust tracks and plates, if applicable, and uncoil
the wall again. If the spread is too wide, measure the wall and check
it against the chart below.
Illustration 8.1
Inside of pool
BOLT
IMPORTANT! A non-compliance installation according to manufacturers' instruction will void the warranty.
A faulty installation will cause the wall or joint to split open which could result in serious and/or fatal injuries!
Chart
MODELS
ACTUAL LENGHT
OF THE WALL
WALL INSTALLATION
PLANKS
ST
TA A KES AND
D
STRINGS
End
NUT
Outside of pool
10x16
10x19
10x22
43' 8"
49' 8"
55' 9"
(13,30m)
(15,14m)
(17,00m)
Join both ends of the wall by orienting folds outward to hide the ex-
clamation icon. (Illustration 8.1)
Note: If the wall is attached properly, you should no longer see
the exclamation icon. If you can always see the icon, you must
reverse the overlap.
Insert bolts and nuts in every hole and tighten with wrench (screw
head on water side of wall). Tape over screw heads with duck tape.
12x18
12x24
15x24
12x21
49' 8 1/2"
61' 9 3/8"
65' 2 1/2"
55' 9 3/8"
(15,16m)
(18,83m)
(19,88m)
(17,00m)
BOTTOM PLATE
Fold
WARNING
: Never use an impact gun for wall screws.
Minimum torque force of 60 inch pounds to
maximum of 85 inch pounds.
15x30
18x33
77' 2 1/2" 86' 7 1/2"
(23,53m) (26,40m)
Inside of pool
Outside of pool
Fold