Publicité
Les langues disponibles
Les langues disponibles
7. Insert the rear grill (5) on the motor shaft by making sure that the three locking pins are
placed into their holes of the rear grill (the carrying handle must be on the top). Then screw
the lock ring of the rear grill (4) by turning it clockwise to fix the rear grill.
8. Place the blade (3) on the motor shaft by taking care to align the slot of the blade with the
pin of the shaft and insert the blade until it locks in place. Then tighten the blade's locking nut
(2) by turning it counterclockwise. Take care to tighten the nut properly. Check that the blade
rotates well by turning it manually.
9. If needed loosen and remove the safety screw on the front or rear grill. Place the front grill
(1) properly on the rear grill (5) by making sure that the logo Fanelite on the central stud is
placed horizontally and that the holes of front and rear grills for the safety screw match. Once
the front grill is properly installed, close the locking clips of the two grills and retighten the
safety screw to secure the assembly.
TABLE FAN
To use the fan as a table fan, follow the above steps of STAND FAN but replace the parts
(17~21) by the parts (25~26).
WALL FAN
To use the fan as a wall fan, follow the above steps of STAND FAN but replace the parts
(17~21) by the parts (23~24).
5. WALL MOUNTING (WALL FAN)
WARNING : The fixing must be done safely in the STRUCTURE of the wall by a
qualified person. We decline all responsibility in the event of a fall of the appliance.
Use appropriate plugs and screws to the structure of your wall.
1. Choose an appropriate place.
2. Pre-drill your wall if necessary before installing your appliance.
3. Insert and tighten 3 screws and plugs (23) matching the structure of your wall into the 3
corresponding holes on the wall bracket (24) to secure your fan to the wall.
6. OPERATING INSTRUCTIONS
WARNING : Before using your appliance, carefully read the safety instructions in this
manual.
Insert a battery 3V CR2032 into the remote control (see section REPLACING THE
BATTERY for more information). Remove the transparent sheet from the battery cover
before use remote control.
Plug in the power cord.
Using the control panel or remote control :
Power ON and speed setting
Press the ON/SPEED button to turn on the fan (the fan starts in medium speed for 3 seconds
then return to low speed). Press again to adjust the speed. The corresponding indicator light
on on the fan.
Indicator L : low speed
Indicator M : medium speed
Indicator H : high speed
18
Publicité
