Explanation Of Buttons - Electrolux EXH09HL1W Manuel D'utilisation

Explanation of buttons

Nr. Button
17 ON/OFF
18 MODE
19 FAN
20 UP ^
21 DOWN v
22 CLOCK
23 LIGHT
24 TURBO
Explanation
Press the button to switch on the unit. Press the button again
to switch off the unit.
Press the button to set the operation mode: AUTO, COOL,
DRY, FAN and HEAT. Default setting: AUTO.
In the AUTO mode, the temperature is not shown. In HEAT
mode, the initial value is 28 °C (82 °F). In other modes, the
initial value is 25 °C (77 °F).
Press the button to set the fan speed: AUTO, LOW, MEDIUM
LOW, MEDIUM, MEDIUM HIGH and HIGH. Default setting:
AUTO. In the DRY mode, only LOW can be set.
Press the button to increase the temperature. Keep the
button pressed for two seconds to accelerate the process.
Release the button to set the temperature and send the order
that the °C/°F signal will be displayed constantly.
Temperature range: 16-30 °C (61-86 °F).
In AUTO mode, the temperature cannot be set. If you press
the UP or DOWN button, a beep will sound.
Press the button to decrease the temperature. Keep the
button pressed for two seconds to accelerate the process.
Release the button to set the temperature and send the order
that the °C/°F signal will be displayed constantly.
Temperature range: 16-30 °C (61-86 °F).
In AUTO mode, the temperature cannot be set, but the order
can be sent by pressing the button.
Press the button to set the clock. If the clock symbol blinks,
press the UP or DOWN button to set the time. Keep the
button pressed for two seconds to accelerate the process.
Press the CLOCK button again to set the clock. The clock
symbol stops blinking.
After battery replacement, "12:00 PM" will be shown. If the
clock symbol is visible, the actual time will be shown. If the
clock symbol is not visible, the timer will be shown.
Press the button to switch the display of the indoor unit on or
off. Default setting: OFF.
In COOL or HEAT mode, press the button to enable or
disable the turbo function. If the turbo function is enabled, the
turbo symbol will be shown. Default setting: OFF.
If the turbo function is enabled, the unit will operate at turbo
speed to cool or heat rapidly so that the ambient temperature
approaches the set temperature as soon as possible.
ENGLISH 5