Check After Installation; Operation Test - Electrolux EXH09HL1W Manuel D'utilisation

22 www.electrolux.com
16. Securely tighten the cap of the
packed valves.
Outdoor condensate drainage (heat-
pump unit only)
During heating operation, condensate
water and defrosting water must be
drained through the drain hose.

Check after installation

Items to be checked
Has the unit been jxed jrmly?
Have you done the refrigerant leakage
test?
Is the thermal insulation sufjcient?
Is the water drainage satisfactory?
Is the voltage in accordance with the
rated voltage on the nameplate?
Is the electrical wiring or piping
connection installed correctly and
securely?
Has the unit been securely grounded?
Is the mains cable as specijed?
Is the air inlet or the air outlet blocked?
Is the length of the connection pipes
and the refrigerant capacity as specijed
Is the length of the connection pipes
and the refrigerant capacity as specijed

Operation test

Before operation test
supply before the installation is
completed.
connected correctly and securely.
pipes must be opened. Refer to the
section "Vacuuming and leakage
test".
1. Install the outdoor drain connector in
a Ø 25 mm hole on the base plate.
2. Attach the drain hose to the
connector so that water in the
outdoor unit can be drained. The
hole diameter 25 must be plugged.
Possible malfunction
The unit may drop, shake or emit noise.
Insufjcient cooling or heating.
Condensation.
Water leakage.
Electrical malfunction or damage to the
unit.
Electrical malfunction or damage to the
parts.
Electrical leakage.
Electrical malfunction or damage to
parts.
Insufjcient cooling or heating.
Inaccurate refrigerant capacity.
Inaccurate refrigerant capacity.
Operation test method
1. Connect the unit to the power
supply.
2. Press the ON/OFF button to switch
on the unit.
3. Press the MODE button to set the
operation mode and check whether
the operation is as expected.