Masterbuilt MES 35B Manuel D'instructions page 22

SYMPTOM
Power light won't come on
Unit takes excessive amount of time to heat up Unit plugged into an extension cord
Grease is leaking out of smoker
No smoke
Temperature rapidly decreased, or shut down
after few hours of use
Power light is on, unit isn't
heating
Controller does not adjust heat
22
OPERATING INSTRUCTIONS
Step 1
Connect controller to smoker body.
Step 2
Plug power cord into an outlet (refer to "Warnings & Important
Safeguards" section of manual).
Step 3
Turn control knob to desired setting.
Indicator light will turn off when set temperature is reached.
Note: Temperature gauge on smoker door reflects setting on
controller and displays temperature inside unit.
TROUBLESHOOTING GUIDE
CAUSE
Not plugged into wall
House circuit breaker tripped
Controller malfunctioning
Door not closed properly
Controller malfunctioning
Drip tray not in place
Excess grease or oil build-up in unit
No wood chips
Faulty control unit
Controller/unit malfunctioning
Controller/unit malfunctioning
POSSIBLE SOLUTION
Check wall connection
Make sure other appliances are not operating
on the same electrical circuit. Check
household circuit breakers.
Contact Masterbuilt at 1.800.489.1581
Set unit so an extension cord does not have
to be used
Close door and fasten latch securely
Contact Masterbuilt at 1.800.489.1581
Reposition so drip tray alines to drain hole in
bottom of unit
Clean unit
Add wood chips
Contact Masterbuilt at 1.800.489.1581
Contact Masterbuilt at 1.800.489.1581
Contact Masterbuilt at 1.800.489.1581