Publicité
Les langues disponibles
Les langues disponibles
INSTALLING NEW SEAL (continued)
Remove ceramic portion of sink (See
"Removing Old Seal"). Grasp copper
cone with fingers at the large end and
move back and forth. Be careful not to
deform it.
COPPER HEAT SINK
INSTALLATION
1. Clean off all sealant and foreign
material.
2. Clean out heat sink cavity in seal
plate.
3. Apply thin layer of non-hardening
Permatex on outer surface of heat
sink (part that fits into cavity,
Figure 12).
Wipe a small amount of
non-hardening Permatex onto
this surface.
Figure 12
Pump Brand
FPP1520
Flotec
FP4001-08, FP4012-08
Simer
3105P
Teel
4AT96, 4AT97
Diamond
314071-01
Craftsman
2805
Seal and Gasket Kit FPP1530 works with all models listed above.
All manuals and user guides at all-guides.com
4. Using standard 7/8" socket, bolt,
and 1-3/8" washer pull heat sink into
cavity (See Figure 13).
1-3/8" O.D.
1
3
⁄
" O.D.
8
WASHER
Washer
Figure 13
5. Clean out any surplus Permatex
from insert cavity where new seal
will be located (Figure 14).
Remove
Remove
surplus
Surplus
Permatex
Permatex
Properly
Properly
seated
Seated
Figure 14
6. Follow steps 2 through 11 under
"Installing New Seal".
For Use With Kit No.:
FPP1521
FP4022-08
3107P
4AT98
301472
–––
3
PUMP REASSEMBLY
1. Install new O-Ring gasket on seal
plate (Figure 15, Key Nos. 5 and 3).
2. Pick up a small amount of liquid
soap on one finger and spread
7/8" Socket
7/8" SOCKET
evenly over O-Ring gasket for lubri-
cation during reassembly. Be care-
ful not to nick or tear O-Ring.
3. Replace motor onto pump body; be
BOLT
Bolt
sure rubber pad stays in place on
top of diffuser. Tighten four hex
nuts and lockwashers snugly
038 0893
(35-45 inch-lbs. torque). Do not
overtighten.
4. Replace pressure switch tubing and
motor wiring.
5. Prime pump according to instruc-
tions; see Operation.
6. Check for leaks.
039 0893
Publicité
