Zycoo SL50 Guide D'installation Rapide page 7

All manuals and user guides at all-guides.com
5.To adjust the angle of the speaker, you can rotate it up or down for maximumly 30 degrees, or left or right for
maximumly 90 degrees.
MAX90°
6.Connect the SL50 speaker to the grounding terminal. If the SL50 speaker is installed with LTE module,
please connect the LTE antenna to the antenna terminal.
Note: It is recommended that the installation height does not exceed 5m.
Web Login
1.Connect network cable and power supply (if PoE is not enabled on the network cable).
2.Wait for 30 seconds then press and hold the RST button for 5 seconds and release, it will announce the IP address
obtained from the DHCP server. If there's no DHCP server or DHCP fails, it will use default IP 192.168.1.101. In the
browser address bar input the IP address you hear to open its web management interface. Default username and
password admin/admin.
Interfaces and Instructions
To reset factory defaults, press and hold the RST button for 10 seconds (5 seconds for IP address announcements)
and release, now you should hear voice prompts "Resetting factory defaults, rebooting...", it means the speaker will
now reset.
To reset factory defaults, please remove the back plate of the SL50 speaker and use the reset button.
05