Chamberlain 8810CB Instructions Pour L'utilisateur page 2

16. With the trolley against the pliers, dispense the remainder of
the belt along the rail assembly toward the opener and around
the sprocket. The sprocket teeth must engage the belt.
17. Check to make sure the belt is not twisted, then connect it to
the flat end of the trolley threaded shaft with the master link
(Figure 4):
• Push pins of master link bar through holes in end of belt and
trolley threaded shaft.
• Push master link cap over pins and past pin notches.
• Slide clip-on spring over cap and onto pin notches until both
pins are securely locked in place.
18. Insert the trolley threaded shaft through the hole in the trolley.
Be sure the belt is not twisted, and the ribbed side faces
the rail.
19. Hold the belt at the trolley shaft as you thread the spring nut by
hand (Figure 5) onto the shaft until finger tight against the
trolley. Do not use any tools.
20. Remove the locking pliers.
21. Set the belt tension:
• Insert a screwdriver tip into one of the nut ring slots and brace
it firmly against the trolley (Figure 5).
• Place a 7/16" open end wrench on the square end. Rotate the
nut about 1/4 turn until the spring releases and snaps the nut
ring against the trolley (Figure 6).
This sets the spring to optimum belt tension.
22. Replace the belt cap retainer and complete the re-installation
and adjustment of your opener according to your owner's
manual. NOTE: Before hanging the opener, an additional
hanging bracket is necessary for stability. See Adding An
Additional Hanging Bracket.
23. Replace the old emergency release rope with the new, longer
replacement rope.
24. Reconnect power and operate the door in the UP direction.
25. Increase the UP travel limit by turning the UP limit adjustment
screw in a clockwise direction as shown on label. One turn
equals 2" (5 cm) of travel.
ADDING AN ADDITIONAL HANGING BRACKET:
Cut the enclosed hanging bracket (cross brace) to fit across the
installed hanging brackets. Fasten the cross brace to the top and
bottom hole of the hanging brackets (Figures 7 and 8) using
5/16"-18x7/8" hex bolts, 5/16 lock washers and 5/16" -18 nuts.
REPLACEMENT PARTS
Part No. Description
183C158-14 Header Rail Extension
183C157-10 Center Rail Extension
41A5250-2 10' Belt Assembly
41A3021 Rope
4A1008 Master Link Kit
41B4103 Spring Nut Assembly
114A2749E
Figure 5
Figure 6
Square
End
To avoid possible SERIOUS INJURY from a falling garage door opener,
fasten it SECURELY to structural supports of the garage. Concrete
anchors MUST be used if installing ANY brackets into masonry.
Figure 7
Lock Washer 5/16"
Nut 5/16"-18
Figure 8
Qty
1
1
1
1
1
1
©2006, The Chamberlain Group inc.
All Rights Reserved
Spring Nut
Trolley
Nut Ring
BEFORE
1" (2.5 cm)
WARNING
CAUTION
Hanging Bracket
(Cross Brace)
Bolt 5/16"-18x7/8"
Hanging Bracket
(Cross Brace)
Lock Washer 5/16"
Nut 5/16"-18
HARDWARE SHOWN ACTUAL SIZE
Hex Bolt
5/16"-18x7/8"
Nut 5/16"-18
Hanging Bracket (Cross Brace) Not shown actual size
Nut Ring
Slot
Square
End
Nut Ring
AFTER RELEASE
1-1/4" (3.18 cm)
Bolt 5/16"-18x7/8"
Lock Washer 5/16"