Unpacking The Device; Installing The Device - Ega Master 51648 Instructions De Montage

Nº. Description
1 Drive wheels
2 Fixed castors
3 Steering castors
Secure the interfaces in the desired positions.
If the installation position is different or if other castors are used, contact your sales partner
CAUTION
Cuts may be sustained on sharp edges on the device.
Wear protective gloves during all work on the device.
Take the device out of the packaging.
Check the device for transport damage.
Contact you sales partner if you discover transport damage.
To install the device on the prepared carriage, you will require the following:
This device (drive unit)
Torque wrench with a setting range to 20 N m
Three M8 screws of minimum strength class 8.8 (DIN EN 24017). Select the length of the
screws according to type of fastening (threaded holes or through holes in the interface)
If fastening with through holes, three M8 nuts of strength class 8
The corresponding tool depending on the fastening type.
CAUTION
Cuts may be sustained on sharp edges on the device.
Wear protective gloves during all work on the device.
In order to fasten the device to the carriage, proceed as follows:
Turn the two screws (2) slightly into the threaded holes of the interface.
Or
Attach the two screws (2) slightly with the nuts to the interface.
Push the device with the open holes of the fastening plate (3) over the two pre-mounted
screws.
Insert the third screw through the hole (1) of the fastening plate and attach this to the interfa-
ce.
Tighten the three screws with a torque of 20 Nm.
Proceed as follows if you are using a unit with stay bolts:
Guide the unit's stay bolts through the corresponding drilled holes in the interface.
Secure the unit to the interface using three nuts.
Tighten the nuts with a torque of 20 Nm.

UNPACKING THE DEVICE

INSTALLING THE DEVICE

FASTENING THE DEVICE
25