Onkyo CS-265 Manuel D'instructions page 28

Listening to the Radio
This manual describes the procedure for using the
remote controller, unless otherwise specified.
Tuning into FM Radio Stations
1 Press the [TUNER] button to change the
input source to FM.
2
While observing the display, press the
[e TUNING]/[TUNING r] buttons to tune
in a station.
Each time you press a TUNING button, the
frequency changes 0.05 MHz steps. If you press
and hold a TUNING button, the frequency will
change continuously. Once you release the button,
tuning will stop automatically when a radio
station is found.
When tuned to a station, the Tuned (
appears. When receiving a stereo FM signal, the FM ST
indicator appears as well.
Presetting FM Stations Manually
You can preset one station at a time up to 30 stations.
In this way, you can tune in a preset station without
adjusting the frequency.
1 Tune into the station that you want to store
as a preset (see page 26).
2
Press the [MENU] button, use the [q]/[w]
buttons to select "PresetWrite>", then
press the [ENTER] button.
3 Use the [q]/[w]buttons to specify the
preset number to which you want to preset
the station, then press the [ENTER]
button.
26
En-
Presetting FM Stations
Automatically (Auto Preset)
Auto Preset Caution
Any existing presets will be deleted when the Auto
Preset function is run.
1 Press the [TUNER] button to change the
input source to FM.
Adjust the position of the FM antenna so that the
FM reception is the best (see page 14).
2 Press the [MENU] button, use the [q]/[w]
buttons to select "AutoPreset?", then
press the [ENTER] button.
) indicator
3
Press the [ENTER] button again.
The Auto Preset function is activated.
Up to 30 stations can be preset and presets are
stored in frequency order.
If you want to cancel the Auto Preset process,
press the [2] button.
Note:
Depending on your location, a preset may be stored
with no station, and you'll hear only noise when you
select it. Delete unnecessary preset channels (see
page 27).
Tuning into weak stereo FM stations
If the signal from a stereo FM station is weak, it may be
impossible to get good reception. In this case, press the
[MODE] button to switch to Mono mode and listen to
the station in mono.
To revert to Auto mode, press the [MODE] button
again.
In general, for stereo reception, set to Auto mode.