Télécharger Imprimer la page

ETQ TG72K12 Guide D'utilisation page 15

Publicité

Les langues disponibles

Les langues disponibles

ETQ
EASTERN TOOLS & EQUIPMENT INC
Figure 4. Engine switch on position
• Pull the recoil starter grip lightly until
resistance is felt, then pull hard.Warning: Do
not allow the starter grip to snap back
against the engine.Return it gently (Figure
5.).
Figure 4. Recoil starting rope
5
• Push the choke rod to the "OPEN" position a
short distance at a time over several seconds as
the engine warms up (Figure 6).
ELECTRIC STARTING
Before starting the engine, verify that the engine oil
is full, gasoline is full, and air filter is in place. Also,
disconnect any load from the AC receptacle, and
turn the AC circuit breaker OFF (Figure 1).
Figure1 .Disconnecting electrical devices
Tel: (888)908-6200
• Turn the fuel valve to the "On" position (Figure 2).
·Place the choke lever in the "CHOKE" position
(Figure 3.).
• Turn the engine switch to the "ON" position
(Figure 4).
Figure 4. Engine switch on position
• Push the choke rod to the "OPEN" position a
short distance at a time over several seconds as
the engine warms up (Figure 5).
12
Web Site: easterntools.com

Publicité

loading

Ce manuel est également adapté pour:

Tg8250