Rega Planar 3 50th Anniversary Edition Mode D'emploi page 7

Setup and connections
1. Only use the Rega supplied PS1 AC adaptor.
2. Connect the power DIN lead (supplied) between the rear of the Planar 3 50th Anniversary Edition and the DIN socket on the rear of the Neo PSU
MK2.
3. Plug the Rega PS1 into the socket labelled '24V AC' and switch the mains power on.
4. To turn the Neo PSU MK2 on, push the power button located on the front panel and the turntable platter will rotate at the selected speed.
5. When the power supply is switched on, if the Rega logo illuminates RED, 331/3 rpm is selected. If the Rega logo is illuminated GREEN, 45 rpm is
selected.
6. To change between speeds, press the button marked '33/45' on the front panel as required.
Note: To minimise the risk of hum picked up by the cartridge, the Neo PSU MK2 should be situated as far from the turntable as the interconnect cable
will allow.
Connecting to the amplifier
The tonearm external phono leads must be connected to a suitable phono stage.
Connect as follows: Red = right channel / Black = left channel
Click to return to top English 7