Cebora CP-162C Manuel D'instructions page 11

• Reconnect connectors A and B, screw in the handle M
and then the retention dowels G1 and G2.
• Tighten the cable gland F.
5.6 REPLACING THE
ADAPTER.
J P AB
W
Remove spring P. Open the cover W by unscrewing the 4
set screws and then screw M. Remove pins of the control
cable X and Z. Take note of the position of each pin and
then remove the U-bolt T and the pins of the pilot arc red
cables Y and Y1. Cut the isolating hose K2 and unscrew
body N from i tting I1. Assemble the new i tting and follow
the previous instructions in reverse direction. Use thread
G1
G2
A
D
C
B
CABLE WITH CENTRAL
T X
M I1 Y Y1
Fig. 10
Fig. 7
the safety efi ciency, the body contacts N must be
sealer to lock the N body thread. To avoid jeopardizing
connected as follows: pins Y and Y1 of pilot arc red
cables to contacts 5 and 6, pin X of cable J to contact
1, pin Z of cable J to contact 9.
Reconnect U-bolt T as described above.
Z N
5.7 WARNINGS
Periodically make sure that the welding torch cable is
intact and has no cuts or excessive wear. Replace it
immediately if needed.
K2
M
G1
Fig. 8
F
11