Publicité
Les langues disponibles
Les langues disponibles
English
Operating
1. Turn the gas tap control knobs clockwise to the 'OFF' position.
2. Connect the regulator to the gas bottle. Turn the gas supply 'ON' at the cylinder. Check with the use of soapy
water for any gas leakage between the bottle and the regulator and the appliance connection.
3. Open the lid fully before lighting the burners. Turn one of the control knobs turning anti-clockwise to the large
flame symbol position, full rate position whilst holding a match to the burner to be lit, this will light the burner. If
the burner does not light, repeat this process.
4. If the burner has not lit after two attempts, turn off the gas tap, wait 5 minutes and then repeat step 3.
Flame adjusting
The flame of each burner can be adjusted according to the symbols contained in each handle.
5. The flame can be adjusted to a low rate position marked with a small flame symbol or any rate between full
and low rate.
Turning the unit off
6. To turn the stove 'OFF' turn the cylinder valve or regulator switch to the 'OFF' position and then turn all of the
control knobs on the appliance clockwise to the 'OFF' position when the flame have extinguished.
NOTE: When the unit is used after being left unused for a considerable period, it sometimes happens that the burner
fails to ignite. This is because air has been trapped in the rubber tubing. Repeat turning the ignition knob a few times
until gas comes through.
6
Publicité
