Publicité
Les langues disponibles
Les langues disponibles
Connecting the Gas cylinder to the gas stove
This appliance is only suitable for use with low-pressure butane or propane gas, fitted
with the appropriate low-pressure regulator via a flexible hose. The hose should be safely
secured to the regulator and the appliance (with hose clips).
The regulator should comply with the EN 12864 standard.
The appliance was set to be connected with a flexible hose and having a length not
exceeding 150 cm.
The hose should comply with the EN 1763-1 standard.
Be sure that after connecting the hose it is not creased or is in contact or near the hot
zones. Whether the tube or the regulator/reducing gas pressure should be certified and
marked in accordance with applicable standards. The fixing of the pipe to the unit and
the gearbox must be done by clamps.
For a better fixation it is recommended that first heats the tube dipping it for one minute
in hot water.
After the connections, check the leakage of the whole gas circuit retaining the ignition buttons off and the bottle
reducing gas pressure knob open, and then applying a mixture of water and soap. The blistering means that
there is gas leakage.
Warning: Accessible parts may be very hot. Keep young children away from the hot appliance at all
times (even while cooling down!).
5
English
Publicité
