Publicité
Les langues disponibles
Les langues disponibles
Trouble shooting
Problem
Check
Status
Engine
Fuel at
No fuel at
cranks,
carbureto
carbureto
start
r.
r.
hard or
does
not start.
Fuel at
No fuel at
cylinder.
cylinder.
Muffler
wet with
fuel.
Spark at
No spark.
end of
plug wire.
Spark at
No spark.
plug.
Engine
Air filter.
Air filter
runs, but
dirty.
dies or
Fuel
Fuel filter
does not
filter.
dirty
accelera
te
properly.
Fuel
Fuel vent
vent.
plugged.
Spark
Plug dirty
plug.
or worn.
Carburet
Improper
or.
adjustme
nt.
Cooling
Cooling
system.
system
dirty or
Cause
Remedy
Fuel
Clean or
strainer
replace.
clogged.
Clean or
Fuel line
replace.
clogged.
See
Carburetor.
local
dealer
Carburetor.
See
local
dealer
Fuel
Open
mixture too
choke.
rich.
Clean or
replace
air filter.
Adjust
carburet
or.
See
local
dealer
Stop switch
Turn
off.
switch to
Electrical
On.
problem.
See
Interlock
address
switch.
on
the
warranty
card.
See
local
dealer
Spark gap
Adjust to
incorrect.
0.65 mm
Covered
(0".026).
with
Clean or
carbon.
replace.
Fouled with
fuel.
Clean or
Plug
replace.
defective.
Replace
plug.
Normal
Clean or
wear.
replace.
Contamina
Replace.
nts or
residues in
fuel.
Contamina
Clean or
nts or
replace.
residues in
fuel.
Normal
Clean
wear.
and
adjust
or
replace.
Vibration
Adjust.
Extended
Clean.
operation in
dusty
Engine
N/A
does not
crank
Warning! Fuel vapors are extremely flammable and
may cause fire and/or
explosion. Never test for ignition spark by grounding
spark plug near cylinder
plug hole, otherwise serious personal injury may result.
Storage
Warning! During operation the muffler and surrounding
cover become hot.
Always keep exhaust area clear of flammable debris
during transportation or when storing, otherwise
serious personal injury may result.
Long Term Storage (over 30 days)
Do not store your hedge trimmer for a prolonged period of time
(30 days or longer) without performing protective storage
maintenance which includes the following:
● Store hedge trimmer in a dry, dust free place, out of the
reach of children.
Warning! Do not store in enclosure where fuel fumes
may accumulate or reach an open flame or spark,
otherwise serious personal injury may result.
● Place the ignition switch in the "STOP" position.
● Remove accumulation of grease, oil, dirt and debris from
exterior of hedge trimmer.
● Perform all periodic lubrication and services that are
required.
● Apply clean oil to the entire length of the blade. Be certain
the blade bolts are
lubricated.
● Install blade cover on blades.
● Tighten all the screws and nuts.
● Drain the fuel tank completely and pull the recoil starter
handle several times to
remove fuel from the carburetor.
● Remove the spark plug and pour 7cc (1/4 oz.) of fresh, clean,
two-stroke engine oil
into the cylinder through the spark plug hole.
● Place a clean cloth over the spark plug hole.
● Pull the recoil starter handle 2-3 times to distribute the oil
inside the engine.
● Observe the piston location through the spark plug hole. Pull
the recoil handle slowly
until the piston reaches the top of its travel and leave it there.
● Install the spark plug (do not connect ignition cable).
Important: Always store and transport hedge trimmers in a
stable, horizontal position.
Support gear case and cutting blades to prevent excessive
flexing, which may cause damage to these components.
Always install blade cover when transporting or storing hedge
trimmer.
30
plugged.
or dirty
locations.
N/A
Internal
engine
problem
See
local
dealer
Publicité
