Publicité
Les langues disponibles
Les langues disponibles
RADIOKEYD-S
1. GENERAL INFORMATION
The RADIOKEYD-S is a 4-channel radio keypad. It has 2 operating mode. In those 2 modes, you'll have to register the keypad in a receiver (like a transmitter programming)
2. MULTI-CODE MODE (by default): (4+9)
Type 5 digits then the key
or
Example 1 : 54321
2 = the transmitted code is 54321 on the channel 2.
Example 2 : 55555
4 = the transmitted code is 55555 on the channel 4.
This mode is mostly used for access control.
2.1 Modification keypad illumination ON/OFF
1
2
2.2 Modification of the buzzer ON/OFF
4
3. MONOCODE MODE: (7+9)
With that mode, the programming will be done directly on the keypad (100 codes max) and the transmitted code in the receiver will be always the same (Factory serial
code)
The code registered in the keypad will be always followed by
All handling (enter an additional code or delete a code) has to be done from the keypad and not from the receiver.
Example: registered code in the keypad: 4321, the code used to activate the gate will be: 4321
3.1 Code programming in Monocode mode
3.1.1 Master code.
When you turn the keypad in monocode mode, to enter in programming code, you must enter the master code. By default the master code is 9999. It is recommended to
change it after the installation.
3.1.2 Master code changing
Press the keys :
0
9999
9 then
new 4-digit master code
3.1.3 Code programming
Press the keys :
0
master code
1 then
Example with the code 123 :
0
9999
1
123
3.1.4 Delete codes
Press keys :
0
master code
1 then
3.1.5 Deletion of all codes
CAUTION: this manipulation will erase all codes except the master code
Press :
0
master code
8
4. LIGHT AND BUZZER PROGRAMMING
4.1. Light programming
Lighting of 10 sec (after pressing the last digit):
0
master code
2
OFF permanently lighting:
0
master code
2
4.2. Buzzer programming.
For an activated buzzer press:
0
master code
4
For an inactive buzzer press:
0
master code
4
4. PROCEDURE TO CHANGE THE PROGRAMMING MODE OF THE KEYPAD
Turn to Monocode Mode: Simultaneously, press keys 7 & 9 (approx.5 sec up to LED flashing).
Turn to Multi-codes modes (by default): Simultaneously, press keys 4 & 9 (approx.5 sec up to LED flashing).
5. ACOUSTIC SIGNALING
Key press
Entrer in programming mode
Entrer into the submenu
Error
Valid code
Wrong code
then the desired channel from 1 to 4.
or
then the channel from 1 to 4. For example, this mode will be used to activate a residential gate.
code from 1 to 4 digits >
'the code to delete'
8
the keypad responds by 2 short beeps.
1
2
1
0
1 beep
1 beep of 2 sec.
1 beep of 1 sec.
5 beeps of 0.5 sec.
Ascendant beeps sequence
Multi ton bas
ISRADIOKEYD-S_07_18
1
NOTE
The symbols in the manual
«
» and «
to the keypads keys
In programming mode it is
important to wait until the
end of beep sequences to
continue to press the keys
» correspond
2
Publicité
