Publicité
Les langues disponibles
Les langues disponibles
FOR VEHICLES WITH 1.25" RECEIVERS
No adapter is needed. Insert the Z-Type Connecting Tube (1) into the vehicle's receiver and align the receiver tube's
holes with the holes on the bike carrier. Place a φ 1/2" Spring Washer (15) and φ1/2" Flat Washer (16) on the outside of
the receiver tube, aligning the holes with the holes in the receiver tube. Insert the φ1/2" Bolt (14) through the φ 1/2"
Spring Washer (15), φ1/2" Flat Washer (16), receiver tube and Z-Type Connecting Tube (1). Secure the assembly with a
Cotter Pin (18). (Refer to the diagram on the previous page, but disregard Part 17).
STEP 8：
Place the bicycle on the product, inserting one tire into each U-Tube Assembly (6). Press the plastic
button in the middle of the Holder (13) to adjust the holder's position so that it compresses the bicycle's front
tire. Secure the tires with the Buckle Pull Belt (19), ensuring the pull belt goes around the U-Tube Assembly
and through the spokes of the bicycle rim. Tighten the belt.
Use the strap (19) to tie the
wheel to the thickest tube.
The front tire
needs to be
compressed.
10
Publicité
