Motorola Solutions IMPRES MN008032A01 Mode D'emploi

m
IMPRES™ Single-Unit
Chargers (SUC)
Safety Leaflet
*MN008032A01*
MN008032A01-AA
Refer to manual MN008031A01 for other
languages:
https://learning.motorolasolutions.com
MOTOROLA, MOTO, MOTOROLA SOLUTIONS
and the Stylized M logo are trademarks or
registered trademarks of Motorola Trademark
Holdings, LLC and are used under license. All
other trademarks are the property of their
respective owners.
© 2022 Motorola Solutions, Inc.
All rights reserved.
Printed in
1. To reduce risk of damage to
the power cords, pull the plug
rather than the cord when
disconnecting from the AC
outlet or the charger.
2. An extension cord should
not be used unless absolutely necessary. Use
of an improper extension cord could result in
risk of fire and electric shock. If an extension
cord must be used, make sure that the cord
size is 18 AWG for lengths of up to 6.5 feet
(2.0 m), and 16 AWG for lengths up to
9.8 feet (3.0 m).
3. To reduce risk of fire, electric shock, or injury, do
not operate the charger if it has been broken or
damaged in any way. Take it to a qualified
Motorola Solutions service representative.
4. Do not disassemble the charger. It is not
repairable and replacement parts are not
available. Disassembly of the charger may
result in risk of electric shock or fire.
5. To reduce risk of electric shock, unplug the
charger power supply from the AC outlet before
attempting any maintenance or cleaning.
6. To reduce risk of injury, charge only the
rechargeable Motorola Solutions Authorized
Batteries listed in the Online User Guide (part
number MN008031A01_). Other batteries may
explode, causing personal injury and damage.
en-US
IMPORTANT SAFETY INSTRUCTIONS
This document contains important safety
and operating instructions. Please read
these instructions carefully and save
them for future reference.
Before using the battery charger, read all the
instructions and cautionary markings on (1)
the charger and (2) the battery.
7. Use of accessories not recommended by
Motorola Solutions may result in risk of fire,
electric shock, or injury.
OPERATIONAL SAFETY GUIDELINES
• This equipment is not suitable for outdoor
use. Use only in dry locations and conditions.
• The room temperature must not exceed
40 °C (104 °F).
• To ensure optimized charging performance,
turn off the radio while charging unless the
radio is transmitting data wirelessly on Wi-Fi
or Bluetooth.
• Connect the charger only to appropriate power
supplies and power cords as listed in the Online
User Guide (part number MN008031A01_).
• The AC outlet to which the power supply is
connected must be nearby and easily accessible.
• Ensure that the power supply cord connected to
the charger is not easily stepped on, tripped
over, or subjected to water, damage, or stress.
• Connect the power supply only to an
appropriately fused and wired AC outlet with the
correct voltage, as specified on the product.
• Disconnect from the line voltage by removing
the power supply from the AC outlet.