List Of Tools - ISC Starline III Instructions De Montage

Information on the base / tools required
Base
Important: The greenhouse does not have a separate
base profile. You can erect your greenhouse on a
previously prepared brickwork or concrete base (see
base diagram), or you can assemble it on an aluminum
base (available as an optional accessory).
Base plan for concrete or brickwork base
Greenhouse External length Internal length External width Internal width
STARLINE III 236 cm
!
Important: : : : :
If you do not wish to place your greenhouse on a
brickwork or concrete base, ensure that you place the
greenhouse on a flat, firm surface. If necessary, use a
spirit level to check that it is level.

List of tools

You will require the following tools for assembly and installation:
Philips Allen key
screwdriver (Size 3) or
(Size 2-3) hex bit No. 3
!
Important assembly instructions:
Do not use a cordless screwdriver to install the pan-head bolts (item 8).
Do not insert the pan-head screws at an angle!
This could destroy the thread in the press-in nuts in the section. The screws must be
inserted without any great resistance being felt. Damage to the thread in the nut
cannot be accepted as a cause for complaint.
Titel_SL3.pmd
216 cm 240 cm
Depth
Tape measure
or folding rule
5
Concrete / brickwork base
It is very important for correct assembly of the
greenhouse that the right angles in the base are all
perfectly square. The base must be dead level, with
perfectly square corners. Please use a spirit level to
check. Important: the base should be deep enough to
be frost-proof.
220 cm
Height
10 cm
s
Concrete or
brickwork
base
Spirit level
01.08.2010, 17:44
Depth Height
10 cm 30 cm (frost depth!)
Important:
The base must be at least 100 mm
deep and 300 mm high. The base
must be dead level, with perfectly
square corners.
Note:
Ensure that there is sufficient
space (s) between the bore holes
and the edge of the internal base.
Safety Cordless
stepladder screwdrivers
5