Polar CB929 Mode D'emploi page 4

UK
To change the operating temperature;
Press and Hold the
1.
Press the or
2.
Press the button to store the temperature.
3.
Manual Defrost
POLAR Back Bar Chillers feature an automatic defrost. However, should the appliance require an additional
defrost period press and hold the
Automatic defrost cycles are every 6 hours and last 20 minutes (factory defaults).
Note: If a manual defrost is started this resets the automatic defrost timer. During
defrost periods the Defrost light is illuminated.
Cleaning, Care & Maintenance
• Switch off and disconnect from the power supply before cleaning.
• Clean the interior of the appliance as often as possible.
• Do not use abrasive cleaning agents. These can leave harmful residues.
• Always wipe dry after cleaning.
• A POLAR agent or qualified technician must carry out repairs if required.
Cleaning the Condenser
Periodically cleaning the condenser can extend the life of the appliance. The condenser is located at the
back of the appliance.
Note: Use a soft brush or vacuum cleaner to clean the fins of the condenser, taking care
not to damage the fins.
Troubleshooting
If your appliance develops a fault, please check the following table before making a call to the Helpline.
Fault
The appliance is not The unit is not switched on
working
Plug and lead are damaged
Fuse in the plug has blown
Power supply
Internal wiring fault
All manuals and user guides at all-guides.com
button for 2 seconds, the "°C" will start to flash.
buttons to change the temperature.
button for 2 seconds.
Probable Cause
Check the unit is plugged in correctly and switched on
Call POLAR agent or qualified Technician
Replace the fuse
Check power supply
Call POLAR agent or qualified Technician
Action