elem Garden Technic MTBE75304 Traduction Des Instructions D'origine page 44

1. Trigger On/Off Switch
2. Upper Handle
3. Cable Retaining Hook
4. Cable and Plug
5. Middle Handle
6. Knob and bolt
1.Assembly of the Lower Handle(Fig.1)
To assemble the lower handles proceeds as
follows:
• Insert the Lower Handle 8 into the locating
holes on each side of the Motor Assembly 9.
•Screwing the screw that making the lower
handle with the Motor Assembly 9 tightly.
Fig.1
2.Assembly of the Middle Handle 5 and
Upper Handle 2, Cable Retaining Hook 3
and Cable clip 7 (Fig.2)
To assemble the Middle Handle and Upper
Handle proceeds as follows:
• Slide the Cable Restraint Hook 3 onto the
Middle Handle 5.
• Position the Lower Handle 8 over the Middle
Handle 5 and align the holes.
Position the Upper Handle 2 over the Middle
Handle 5 and align the holes.
Push through the two Securing bolts. Screw on
the Securing knobs 6 and hand tighten.
DESCRIPTION
7. Cable clip
8. Lower Handle
9. Motor Housing
10. Protective Shield
11. Tines
ASSEMBLY
• The Securing knob and bolt 6 should be hand
tightened only.
Never use a spanner or any other tool to
tighten them.
• Use cable clip 7 to clip the cable on lower
handle 8 and Middle Handle 5 .
Fig.2