LaserLiner 1697323 Mode D'emploi page 22

Frequency and duty factor measurements
6
1.
Hz / %
Resistance measurement
7
1.
Ω
Diode test
8
1. 2.
Diode test
If „O.L." appears on the display instead of a measured value, the diode has either been tested in
the reverse direction or is faulty. If 0.0 V is measured, the diode is faulty or a short-circuit has occurred.
Capacitance measurement
9
1.
Capacitance measurement
22
EN
2.
AC, DC, Hz
and % selection
2.
Ω, continuity
check and diode
check selection
3.
Ω, continuity
check and diode
check selection
2.
Black
Connect the measuring contacts
to the object to be tested
3.
Connect the measuring contacts
to the object to be tested
3.
Connect the measuring contacts
to the object to be tested
Red Black
3.
Red
Black Red
Black Red
Red Black
Forward direction
In the case of poled capacitors,
connect the positive pole to
the red test prod.