warmhaus Dallas DSF-1/0302 Instructions Importantes – Mode D'emploi page 5

Troubleshooting
Problem
Unit does not work / does not heat
No flame effect
Replacing the Light Bulb

This fireplace consists of 2 bulbs (E-12, 40W) that illuminate a flame effect. The light
bulbs need to be replaced if you notice a dark section of the flame or when the flames
lose clarity.

Warning - Always disconnect from the power outlet before removing bulbs to reduce the
risk of fire, electric shock or damage to property.

Warning - The bulb reaches high temperatures during operation. Allow it to cool down
before replacing it.

Access the bulb panel located on the rear panel of the fireplace (see figures below).

Access the bulb by removing the four screws located on the back panel.

Replace the bulb with a new one. Extra caution should be taken because the bulb can
be hot.

Close the panel lid using screws.

Warning – Do not use fireplace without properly putting the lid back in place.
Possible Solution
· Check if the unit is plugged in the power
outlet.
· Check if the unit is in Standby mode. If so,
turn the unit ON.
· Check if the heat is turned OFF.
·
Check for safety cut-off operation.
· Check if the unit is plugged in the power
outlet.
· Check if the unit is in Standby mode. Turn
the unit ON.
5