Siemens PA0620M Mode D'emploi page 28

c
d
• The accessory has two holes on the side to
fit it to the window / balcony with. The user
can secure it to the frame or wall with two
screws (not included with the accessory) to
prevent it from moving or falling out of place,
Fig. 15.
Permanent installation
Permanent installation is performed using the
wall grommet. See "Description of
accessories".
To expel hot air through the wall, it is
necessary to make an 14-cm diameter hole
in the wall and fit the wall grommet, Fig. 16.
Instructions for Use
Remove the diffusion sleeve and connect
the air expulsion tube to the accessory.
Notes
Do not extend the hot air expulsion tube
more than necessary (maximum length;
140 cm).
Fig. 14
Do not form sharp bends when positioning
the tube, otherwise the correct expulsion
of hot air may be impeded. This may cause
a reduction in the cooling power and
performance of the appliance.
In order to achieve maximum cooling
efficiency and minimum noise levels, the
expulsion tube should be fitted above the
total height of the appliance, Fig. 17.
Fig. 17
Fig. 15
28
24 - 38 cm.
Fig. 16