Yamaha PWK-242 Mode D'emploi page 5

4. Attach the wall mounting unit firmly to
the surface of the wall.
• When attaching the wall mounting unit,
drill at least 2 deep holes in the wall for
the mounting screws to a balanced
mounting.
Arranging cables
• When arranging power and signal cables on
the rear of the unit, use cable clips to prevent
damage to the cables.
Attaching mounting fixtures to the plasma display monitor
1. Remove the stand
(1) Remove the 4 screws from the rear of
the plasma monitor and then remove
the stand.
(2) Remove the 4 continuous thread
screws attaching the earth on the rear
cover.
2. Attaching the plasma monitor mounting
bracket.
• Use 4 M6x18 screws to attach the
monitor mounting rack to the plasma
monitor.
Notch
Use the washers
included as necessary.
Cable clip
Remove the 4 screws
and the stand
Wall mounting unit
Ensure that you are
attaching the
mounting unit to a
strong support.
Remove the 4 continous
thread screws
Second hole from
the top of the
monitor mounting
bracket
Fifth hole from the
top of the monitor
mounting bracket
4