Yamaha PWK-242 Mode D'emploi page 4

Installation
Assembling the wall mounting unit
Using 4 M6x18 screws, assemble the wall mounting unit.
Attaching the wall mounting unit to a wall
1. Prepare 4 sets of screws or anchors (commercially available) to suit the wall you wish to mount
the unit on.
2. Read this installation manual thoroughly, then decide on a suitable location for the plasma
monitor.
3. The position of the outer edge and screen of the plasma monitor and screw holes on the wall
mounting unit are depicted in the diagram below. Anchor the wall mounting unit and drill screw
holes as indicated in the diagram.
• Check that the wall and screws you want to mount this unit on are strong enough to hold the plasma
monitor unit.
Plasma monitor
external dimensions
3
Wall mounting unit
414 (16-5/16)
Screen
center
300 (11-13/16)
400 (15-3/4)
450 (17-11/16)
500 (19-11/16)
1030 (40-9/16)
4 M6x18 screws
Wall mounting unit
(B)
Screw holes 7x20
(1-3/8)
126 (4-15/16)
Unit: mm (inches)
Notch
Wall mounting unit
(A)
(C)
35