Publicité
Les langues disponibles
Les langues disponibles
CUSTOM PROGRAM
If you have a special combination of settings that
you use frequently, you can save these settings
as a CUSTOM PROGRAM.
*
To Save a Custom Program:
Turn on the dryer and turn the cycle selector
1
knob to select the desired cycle.
Use the cycle setting buttons to adjust the
2
settings for that cycle.
Press the cycle option button(s) for the option
3
you would like to add. A confirmation message
will be shown in the display.
Press and hold the CUSTOM PROGRAM button
4
for 3 seconds.
STEAM FUNCTIONS
To Fill the Steam Feeder
Pull out the drawer.
1
Lift out the steam feeder.
2
IMPORTANT NOTES ABOUT STEAM CYCLES
Before using a Steam Cycle, the steam feeder must be filled with water up to the MAX line. If not, the ADD
WATER light will blink. Make sure that the steam feeder is filled with water and the drawer is completely
closed. Turn the dryer off then restart the Steam Cycle.
• O nly use water. Do not fill the steam feeder with foreign substances, rinse agents, or detergents.
• Before moving the dryer, make sure the steam feeder is empty.
• Do not use distilled water; the water level sensor in the steam generator will not work.
• Be careful to put the Steam Feeder otherwise water will be overflow.
• Wipe up any spilled water around the Steam Feeder and the drawer before starting the dryer.
wWARNING:
• D o not fill the steam feeder with liquids such as gasoline, dry-cleaning solvents, or other flammable or explosive
substances. They give off vapors that could explode.
• Do not fill the steam feeder with hot water (over 86°F/30°C).
32
• Do not drink water from the steam feeder.
NOTE: You may only save one custom
program at a time. Pressing and holding the
CUSTOM PROGRAM button will overwrite
any previously saved custom program.
To Recall a Custom Program:
1
2
3
Fill the steam feeder to MAX with water.
3
Steam
Drawer
Feeder
Place the steam feeder in the drawer; then
4
push in the drawer until it clicks into place.
Turn on the dryer.
Press the CUSTOM PROGRAM button.
Press the START/PAUSE button to start
the cycle.
Water
ONLY
Publicité
