Publicité
Les langues disponibles
Les langues disponibles
•
Align handles
a
2
handle screws
and tighten. Do not over-tighten.
1
•
Align
with
(packed separately), press
8
6
until
protrudes out open hole in
8
7
•
Align the
, assembled bracket and
9
screw hole on the drum as the order shown in the
image above. Tighten them clockwise. Note: parts
may need to be exed slightly to allow for proper
alignment.
•
Repeat above process for opposite side of fan.
Fan Operation:
3.
with the cradle in its upright position. The fan
itself can be titled into various positions
depending on applications, including straight
upward.
Fan Location:
4.
the room that will provide the most effective
air circulation.
Fan Connection:
5.
120 volt A.C., 60Hz wall outlet. Be sure plug
cause overheating and damage to the plug
or fan.
NOTE:
To prevent overloading a circuit, do
not plug the fan into a circuit that is servicing
other electrical loads.
Turning Fan On:
6.
level surface. Plug fan into properly grounded
outlet. To start the fan, turn the switch from
the OFF position to the desired fan speed.
Turning Fan Off:
7.
the switch from the current fan speed setting
to the off position. Remove plug from outlet.
Adjusting Fan Tilt:
8.
adjustment knob until the drum rotates freely
on the frame. Adjust the fan to desired tilt
angle and re-tighten the knob. Do not
overtighten adjustment knob.
CARE and MAINTENANCE
Cleaning:
WARNING:
Before cleaning the fan be sure
to disconnect power cord from the plug.
Clean the grille surface with a clean damp cloth.
Do not use harsh chemical or abrasive cleaners.
n
d
3
8
10
Always operate the fan
Place the fan in an area in
Plug fan directly into
Place fan on stable
To turn the fan off, turn
Loosen the
WARNING:
4
OR ANY WIRES IN WATER. Replace front grille
before fan use and allow fan to dry completely
into
6
before use. Periodic grille cleaning with a
.
vacuum will prevent dust build up. The motor
with the
is sealed and does not require any interior
maintenance, cleaning or lubrication.
Maintenance:
are permanently lubricated at the factory and
do not require any additional lubrication.
Repair:
WARNING:
WITHOUT THE GRILLE IN PLACE. DO NOT
USE THE FAN IF IT HAS MALFUNCTIONED
OR BECOME DAMAGED IN ANY WAY.
Storage:
of the fan.
Coil and tie the power cord to avoid damage
during storage.
Free warning label replacement:
warning labels become illegible or are missing,
please call 1-888-899-0146 for
free replacement.
OPTIONAL ACCESSORIES
WARNING:
those offered by D
tested with this product, use of such
accessories with this appliance could be
hazardous. To reduce the risk of injury, only
D
WALT recommended accessories should be
E
used with this product.
DO NOT IMMERSE THE FAN
The Internal motor bearings
DO NOT OPERATE THE FAN
Keep original carton for storage
Since accessories, other than
WALT, have not been
E
ENGLISH
If
5
Publicité
