Publicité
Les langues disponibles
Les langues disponibles
READY TO START!
A. DEVICES & PARTS
DRONE - See illustration 1
A. Camera
B. Propeller
C. Motor
D. Landing gear
REMOTE CONTROL - See illustration 2
1. ON/OFF button
2. Fine-tuning left / right
3. Fine-tuning front / back
4. Joystick controller (front, back, left, right)
5. Flip-button – Auto Return
6. 2.4G Antenna
7. LED-light ON/OFF – Headless mode
8. Speed-switch (beginner – intermediate – advanced)
9. Joystick controller (higher, down, rotation left and right)
10. Fine-tuning higher / lower
11. Fine-tuning rotation left / right
12. LED indicator
B. CHARGING / INSTALLING THE BATTERY - See illustration 3 + 4
We strongly recommend to charge the battery completely before using it for the first time.
To charge the battery, connect the power connector with the included USB-charging cable. Then
connect the USB-charging cable with your computer or any USB-charging device. The LED-light on
the charger will light up red when the battery is fully charged.
To mount the battery into the drone, push the lid with the camera to the back. When the lid is
open, slide the battery into the foreseen compartment and connect the power connector with the
foreseen connection on the drone. Close the lid and slide it back to the front.
When the battery is almost empty, the LED-lights on the drone will start flashing.
The remote control works with 4x 1.5V AA-batteries (not included). To install the batteries, use
the included screwdriver to remove the screw of the lid on the backside. Remove the lid and
install the 4x 1.5V AA batteries according to the scheme. Replace the lid and tighten it with the
screw again.
TIP: always remove the batteries after using the drone or the remote controller to extend the
lifespan of the batteries.
-5-
Publicité
