JBM 54245 Guide D'utilisation page 17

REF.54245
Note: Put the support discs between the feet
and the central support.
If you need to adjust the height, you can use
the height adapters (H and J).
The fine adjustment of the height is performed
by rotating the threaded part of the support
foot (D).
Place the bearing on the central support.
Put the screw through the bearing and screw
the nut (G).
You can adjust the height with adapters S and
T.
As you screw the nut (G), the screw will extract
the injector.
For the extraction of the injector, it is possible
to use the hydromechanical cylinder instead of
the bearing and the nut.
Connect the hose of the hydraulic pump to the
hydromechanical cylinder.
Press the pump lever to extract the injector.
· 17 ·