JBM 54245 Guide D'utilisation page 15

REF.54245
In case you need it, you can adjust the height
with the height adaptors (H and J).
You can use different configurations to adjust
the height.
Place the washer with bearing (K) on the cen-
tral support.
Put the screw (E) through the bearing and
screw the nut (G).
You can adjust the height with adapters S and
T.
Each configuration is suitable for a type of
adapter.
Configuration
1
2
3
4
Tighten the screw (or the extension attached
to the screw) to the adapter already fastened
to the injector.
Make sure that the support is totally perpendi-
cular to the axis of the screw.
When tightening the nut (G) the bearing must
rest perfectly on the support. If not, adjust the
position by rotating the threaded part of the
support feet.
· 15 ·
Adapters
N – O – P – Q – R
M
M with deeper injectors
N – O – P – Q – R with
deeper injectors