Publicité
Les langues disponibles
Les langues disponibles
Installation
Case 2. With disposal
With disposal
3. Check the size of the sink's drain hose connector. If needed, cut the drain hose so its
end fits onto the sink connector (
of the drain hose does not fit onto the drain hose connector of the sink, use an adaptor
purchasable at a plumbing/hardware supply store.
4. Slide a hose clamp over the end of the drain hose. Attach the drain hose to the sink
connector, slide the hose clamp to the end of the hose, and then tighten the hose
clamp.
NOTE
You must use a hose clamp. Failure to do so may cause water leakage.
5. To prevent backflow, secure the drain hose to the side or back wall of the kitchen
cabinet using cable ties or other fixtures. Make sure the drain hose height is at least
10 inches from the sink connector. (See Figure 10.)
6. When drilling a hole for the drain hose on the cabinet wall, take caution not to damage
the drain hose by sharp edges of the hole. On wooden walls, use sand paper to soften
the edges.
On metal walls, use insulation tape or duct tape to cover the sharp edges around the
hole.
30
English
DW7000B_DW80B7070_AC_DD68-00242B-01_EN.indd 30
DW7000B_DW80B7070_AC_DD68-00242B-01_EN.indd 30
Air gap
Hose clamp
Disposal with an air gap
Knock out plug in garbage disposal before
connecting the drain hose.
5
/
in. or 1 in. - as shown in Figure 9 below). If the end
8
Drain
hose
Hose clamp
Without an air gap
2022-03-24
2022-03-24
6:00:01
6:00:01
Publicité
