Orbegozo RH 2500 Manuel D'instructions page 14

RH 2500
You can check the model you have purchased by looking at the appliance's technical label.
ASSEMBLY RH 2500
The oil radiator is packed with the wheels not assembled. Please make sure that they are right
assembled before turning the device on.
Remove the heater and all the accessories from the carton.
1- Turn the radiator upside down carefully and place it over a carpet or any other soft surface in order
not to damage the unit.
2- Pass the "U bolt" in between the last and next-to-last fin and make it fit the holes of one of the
support. Screw the U bolt to the curved support with the help of the wing nuts. Then, screw the
wheels to the support. See picture below.
3- Repeat step 2 in between the first and the second fin, using the other support.
4- Turn the heater the right way up. The unit should be as shown in below picture
USING THE THERMOSTAT AND POWER SWITCHES
1. Select the power of the radiators by pressing the switches:
I II I + II (III)
RH 2500 1000W 1500W 2500W
2. Room temperature can be adjusted using the thermostat. Simply turn the thermostat knob
clockwise, to increase the heat, and anti-clockwise to decrease the temperature, until you reach the
desired temperature.
3. The power switches light up when activated.
4. The thermostat control knob lights up when the unit is heating up. Once it reaches the set
temperature, the light will come off.
5. Once you have finished using your heater, unselect the power switches, and turn the thermostat
control switch to the "0" position, and unplug from the mains supply.
Note: This radiator heater is oil filled, and will cool down slowly after the power is shut off. Allow the
radiator heater to cool prior to any movement; the built carry handle should be used for easy
14