Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION & OPERATION
Installation must only be conducted by a qualified technician.
This device complies with Part 15 and RSS-GEN of the FCC and IC
Rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) This device must
accept any interference received, including interference that may
cause undesired operation.
Installation:
1) Install the mounting bracket by using the screws
2) Slide the RX set onto the bracket
3) Connect the main cable to the RX
4) Connect external antenna to the RX
`
Antenna Location:
1) Place external antenna on the windshield at the point
(Horizontal or Vertical) as shown in the following picture:
Operation:
1) Charge TX for at least 3 hours
2) Switch the power on (located on the bottom of the TX)
3) Place TX into RX to synchronize
Note: Disconnect the battery or turn off the device when the TX is not in use
for long period of time.
7
PACKAGE CONTENTS for ARB-HT3G
- Transmitter (TX)
- Receiver (RX)
- Plug-in Microphone (MONO)
- Mounting Bracket for Receiver with Screws
- Rechargeable Li-Ion Battery
- Leather Pouch
- External Antenna
- Desktop Charger for Transmitter
- Charger Stand for Desktop Charger
- RF Main Cable
- In-car Microphone (MIC)
- User Guide
PACKAGE CONTENTS for ARB-HT3N (option)
- Transmitter (TX)
- Plug-in Microphone (MONO)
- Rechargeable Li-Ion Battery
- Leather Pouch
- Desktop Charger for Transmitter
- Charger Stand for Desktop Charger
- User Guide
8
Publicité
