Panasonic Toughbook Arbitrator ARB-HT3G Guide De L'utilisateur page 3

SPECIFICATIONS
Power DC 3.7V
Frequency (MHz) 900MHz FHSS with 902.5 - 927.5MHz
Number of Channel 51 Channels
Channel Space 500KHz
Speech Coder 8kHz Mono
Type of Modulation GFSK MODULATION / DEMODULATION
Power Typical:170mA
Consumption
Battery Life Talk Time: 12 Hours
Charge Time: 3 Hours
Battery Capacity Lithium-Ion Polymer
3.7V DC/1800mA
TX Power Levels Max Peck Power. 21dBm
Operating: 14℉ - 122℉ ( -10°C - 50 °C )
Temperature Range
Storage: -4℉ - 140℉ ( -20℃ - 60 ℃ )
Dimensions TX: 50mm x 29.35mm x 71.2mm
(L x W x H)
(1.97" x 1.16" x 2.8")
3
CAUTION
Warning
Do not continue charging the battery if it does not charge within the specified
charging time. Doing so may cause the battery to become hot, explode, or
ignite. There is a risk of explosion if the battery is replaced by an incorrect
type.
Dispose of used batteries according to the instructions.
(Please refer to below instruction for safe disposal of lithium polymer battery)
2. While Charging
Caution
The temperature range over which the battery can be charged is
10°C to 45°C. Charging the battery at temperatures outside of this range
may cause the battery to become hot or to break. Charging the battery
outside of this temperature range may also harm the performance of the
battery or reduce the battery's life expectancy.
3. When Discharging the Battery
Danger
Do not discharge the battery using any device except for the specified device.
When the battery is used in devices aside from the specified device it may
damage the performance of the battery or reduce its life expectancy, and if
the device causes an abnormal current to flow, it may cause the battery to
become hot, explode, or ignite and cause serious injury.
Caution
The temperature range over which the battery can be discharged is
-10°C to 45°C. Use of the battery outside of this temperature range may
damage the performance of the battery or may reduce its life expectancy.
Safe Disposal of Lithium Polymer Battery
1) Battery cells be fully discharged before disposal.
2) If physically damaged, it is not recommended to discharge battery cells
before disposal.
3) Battery must also be cool before proceeding disposal.
4) Submerge the battery into a bucket or tub of salt water. This container
should have a lid but it does not need to be air-tight. Allow the battery to
remain in the tub of slat water for at least 2 weeks.
5) Remove the battery from the salt water and dispose of as hazardous waste.
4