Profile 545144122 Manuel D'utilisation page 28

Mobile air conditioner 12000 BTU
545144122
Dehumidifying the room
Press the MODE button on the control panel or the remote control, the LED of the DRY function lights up.
Note: In this mode, the fan automatically switches to low speed. The user must have connected the hose to the drain
opening on the bottom of the unit.
Sleep Mode
Sleep mode can only be activated in COOL mode.
After 1 hour, the set temperature will increase by 1 ℃, after another hour, the set temperature will increase by 1 ℃.
In COOL mode :
Timer:
The timer can be operated in two ways:
To turn off the unit:
Press the timer button to activate the timer function. Press UP/DOWN repeatedly to determine the duration.
To turn on the unit:
Press the Timer button to activate the timer function. Press UP/DOWN repeatedly to determine the duration.
To cancel the timer: Press the UP/DOWN button repeatedly until the LED indicates '00'. Note: The timer can also be
turned off by pressing POWER.
Automatic defrosting
At low room temperatures, frost can accumulate on the evaporator. The unit will then start defrosting automatically
(POWER LED flashes).
Overload protection
In the event of a power failure, the compressor is protected by a delay of 3 minutes until the unit restarts.
Self-evaporating system and water tank
The self-evaporating system uses the collected water to cool the condenser coils for better performance. The
condensation water evaporates at the condenser and is discharged through the exhaust hose.




Turn off the device before using it.
Remove the plug from the water
outlet and keep it in a safe place.
Connect the drain hose securely and
securely, making sure it is not kinked
or clogged.
Place the drain hose over a drain or
Remove the rubber plug.
EN - 6