Publicité
3
FIG.4 - MOUNTING / DISMOUNTING INSTRUCTIONS
For DIN rail fastening according to IEC 60715 TH35-7.5(-15)
Mounting as shown in figure, with input terminals on lower side, with suitable cooling and maintaining a proper distance between adjacent devices as specified in the
Installation Instruction of each family.
MOUNTING:
1. Tilt the unit slightly backwards.
2. Fit the unit over the top edge of the rail.
3. Slide it downward until it hits the stop.
4. Press against the bottom for locking.
DISMOUNTING:
1. Pull down the slide clamp lever
2. Tilt the unit upward
3.
Unhook the unit from the rail
FIG.5 - RECOMMENDED CONNECTING CABLE
Recommended Tightening torque
0.5 - 0.6 Nm
4.42 - 5.30 lbf in
Manufacturer
Bel Fuse Inc.
206 Van Vorst St.
Jersey City
NJ 07302, USA
INSTALLATION INSTRUCTION
1
3
1 & 2
Asia-Pacific
+86 755 2988 5888
© 2021 Bel Power Solutions & Protection
2
4
3
Solid: 2.5 mm² / 12 AWG
Stranded:1.5 mm² / 12 AWG
L: 6.0 - 7.5 mm / 0.24-0.30 in
North America
Europe, Middle East
+1 408 785 5200
+353 61 225 977
BCM.00463_AD
Publicité
