Publicité
LDX-L30 Series
USER INSTRUCTIONS
DESCRIPTION
DIN rail mountable Settable sealed Lead Acid Battery dual voltage housing.
INSTALATION
Use DIN-rails according to EN60715. Installation should be made vertically (see Fig.4). For better device stability fix the rail to the wall close to the point where the device
is to be mounted. In order to guarantee sufficient convection, we recommend observing a minimum distance to other modules (see Fig.3).
CONNECTIONS
The device is equipped with pluggable screw terminals. To avoid sparks, do not connect or disconnect the connectors before having previously turned-off input power
and waited for internal capacitors discharge (minimum 1 minute)
In order to comply with UL certification, use appropriate copper cables of indicated cross section, designed for an operating temperatures of:
60°C for ambient up to 45°C
75°C for ambient up to 60°C
90°C for ambient up to 70°C
Strip the connecting ends of the wires according to the indication and ensure that all strands of a stranded wire enter the terminal connection (see Fig.5)
INPUT PROTECTION
The device input is provided with polyswitch against overcurrent.
DC INPUT / OUTPUT CONNECTION
Connect BATT. + terminal to + pole, BATT. - terminal to - pole.
The device is suitable for SELV and PELV circuitry.
WARRANTY
Battery pack are guaranteed free from factory defects for the time specified in the "Sales Conditions"
Failures caused by misuse, external and/or abnormal events (i.e. overvoltage, over temperatures) or non-respect of above parameters and standards, are not covered by
warranty. Opening the housing of the product makes warranty to be no longer valid.
BATTERY
Please pay attention, the batteries are not included, we recommended to use batteries with final dimension (W x H x D) 48.5 x 54.5 x 97.5 mm Max terminals included.
FIG.1 - CONNECTIONS
(1) Battery Connection
(2) Place wire Jumper to Set 24 VDC /1.2 Ah
(3) Place wire Jumpers to Set 12 VDC /2.4 Ah
Attention!
Do not Set the configuration 2 and 3 at the
same time.
FIG.2 - DIMENSIONS
Dimension
mm (inc)
W
54 (2.12)
D
110 (4.33)
H
115 (4.52)
FIG.3 - DISTANCES
mm (inc)
Distance
20
A
B
20
tech.support@psbel.com
2
Publicité
