YATO YT-828137 Notice Originale page 17

PRODUCT OVERVIEW
The chainsaw is only intended for cutting wood. The chainsaw electric drive allows it to be used under a canopy or near buildings.
Thanks to the battery power supply, the pruning shears allow you to work in places where mains-powered products could not be
used. It can be used for cutting trees, but due to the hazard, it is required that an experienced user performs the cutting operation.
Proper, reliable and safe operation of the tool depends on appropriate use, that is why you should
Read the entire instructions manual before the first use of the tool and keep it for future reference.
The supplier shall not be held liable for any damage or injury resulting from improper use of the tool and failure to observe the
safety regulations and recommendations specified in this manual. Use of the tool for purposes other than those for which it was
intended shall cause the loss of the user's rights to a warranty and statutory warranty.
PRODUCT EQUIPMENT
The power saw is supplied complete but requires assembly before first use. The following elements are supplied with the power
saw: a chain guide bar, a cutting chain and a guard for the guide bar. In addition to the YT-828137, a battery and a charging
station are included.
TECHNICAL DATA
Parameter
Part no.
Rated voltage
Chain speed
Guide bar length
Chain scale
Guide slot width
Protection class
Protection rating
Oil tank capacity
Weight (without the battery, guide bar and chain)
Noise level
- LpA ± K (pressure)
- LwA ± K (power)
Vibration, ah ± K (front/rear handle)
Battery type
Battery capacity*
Battery energy
Charger*
Input voltage
Mains frequency
Rated power
Output voltage
Output current
Charging time**
* only for models equipped with a battery and charger
** the specified charging time applies only to the battery with the capacity listed in the table
The declared noise emission value has been measured using the standard test method and can be used to compare one tool to
another. The declared noise emission value can be used in the preliminary exposure assessment.
The declared total vibration value has been measured using the standard test method and can be used to compare one tool to
another. The declared total vibration value can be used in the initial exposure assessment.
Caution! The vibration emission during tool operation may differ from the declared value, depending on the manner the tool is
used.
Caution! Safety measures to protect the operator, which are based on an assessment of exposure under actual conditions of
use (including all parts of the work cycle, such as the time when the tool is switched off or idle and the activation time), must be
specified.
O R I G I N A L
EN
Unit
[V]
[m/s]
[mm / '']
[mm / '']
[mm / '']
[ml]
[kg]
[dB] (A)
[dB] (A)
[m/s2]
[Ah]
[Wh]
[V~]
[Hz]
[W]
[V]
[A]
[h]
I N S T R U C T I O N S
Value
YT-828137, YT-828138
18 d.c.
6.5
305 / 12
9.525 / 3/8
1.27 / 0.050
III
IPX1
210
3.3
97.0 ± 3.0
102.0 ± 2.66
5.407 ± 1.5 / 4.137 ± 1.5
Li-ION
4
72
220 – 240
50/60
60
21 D.C.
2.4
2
17