Perel WC207 Mode D'emploi page 4

4. Overview
Refer to the illustrations on page 2 of this manual.
1
5. Operation
General Key Function
SET
ALARM
UP
DOWN
SNOOZE
Setting the Time
1. Hold SET pressed for 2 seconds to enter the time setting mode. The value will
flash.
2. Increase/decrease the value with UP/DOWN. Confirm with SET.
You will automatically exit the time setting mode and save the set data if no key is
pressed for 30 seconds.
Setting the Alarm
Hold ALARM pressed for 2 seconds to enter the alarm setting mode. The value will flash.
Increase/decrease the value with UP/DOWN. Confirm with ALARM.
You will automatically exit the alarm setting mode and save the set data if no key is
pressed for 30 seconds.
When the alarm goes off, it will buzz for 2 minutes unless you press SNOOZE. In snooze
mode, the alarm will go off after 5 minutes. Press any other key to switch off the alarm.
Radio-controlled reception
Radio-controlled reception is automatically active after having reset or switched on the
appliance.
Reception happens daily at 2:05, 3:05, 4:05 and 5:05 and lasts 7 minutes. If reception
failed, hold UP pressed for 2 seconds in normal time display to enter the forced
reception mode.
During reception, the reception symbol
symbol will be displayed fully.
If necessary, press UP during reception to exit and abort the reception.
V. 01 – 18/10/2019
display
Enter the time setting mode, confirm, return to normal time display
Check the alarm time, enter the alarm mode, switch the alarm on/off
Increase value, enter the radio-controlled reception mode
Decrease value
Enter the snooze mode
time zone → 12/24h → language → year → month →
date → hour → minute → °C/°F → exit
alarm hour →alarm minute → exit
WC207
2
Setting sequence
Setting sequence
will flash. Once the time is received, the
4
function buttons
©Velleman nv