Emglo K5HGA-8P Guide D'utilisation page 23

CODE POSSIBLE CAUSE
22 Engine problem
23 Engine or pump oil is low
24 Regulator is not adjusted correctly for accessory being
used
25 Damaged regulator
26 Detergent type oil being used in pump
27 Extremely light duty cycles
28 Piston rings damaged or worn
29 Cylinder or piston damaged or worn
30 Compressor cylinder finish worn
31 Water in pump oil
32 Manual lock unloader lever in open position
POSSIBLE SOLUTION
Contact an EMGLO factory service center or an EMGLO
authorized service center.
Add EMGLO Synthetic Blue compressor oil to pump. See
Compressor Pump Oil under Maintenance.
It is normal for some pressure drop to occur when an acces-
sory is used, adjust the regulator as instructed in Regulator
under Features if pressure drop is excessive.
NOTE: Adjust the regulated pressure under flow conditions
while accessory is being used.
Replace.
Drain oil and refill pump with EMGLO Synthetic Blue
compressor oil.
Run unit for longer duty cycles. It is recommended to run at
high throttle 50-75% of the run time and idle for 25% of the
run time.
Contact an EMGLO factory service center or an EMGLO
authorized service center.
Contact an EMGLO factory service center or an EMGLO
authorized service center.
Contact an EMGLO factory service center or an EMGLO
authorized service center.
Drain oil and refill pump with EMGLO Synthetic Blue
compressor oil.
Rotate manual lock unloader lever to the closed perpendicular
position.
23