CEBEK TL-15 Guide Rapide

Télécharger ce manuel

Two-channel transmitter compatible with Cebek TL-1, TL-2, TL-3, TL-4, TL-7, TL-8, TL-9, TL-10, TL-101, TL-102,

TL- 103 and TL-104. Supports security code with 13,122 different combinations.

Incorporates code selection microswitches, LED indicator, and connection terminals.

POWER SUPPLY : Connect the 12 VDC power supply to the POWER terminal, respecting the ± polarity. Keep the

distance from the power supply to the circuit as short as possible.

Install a switch for circuit protection and your own safety, according to CE standard.

To power 230 V AC you can use our recommended power supplies FE-103 or FE-300.

Before activating the switch, make all other circuit connections.

INSTALLATION : Install two pushbuttons on the terminals. The length of the pushbutton cables must not exceed 30

cm. since it can affect the correct functioning of the circuit.

ANTENNA : A 130 mm rigid cable is supplied with the circuit. , connect to the antenna terminal marked as "Y".

For greater range and optimal performance you can use our Cebek C-0509 / C-0510 antennas.

Émetteur à deux canaux compatible avec Cebek TL-1, TL-2, TL-3, TL-4, TL-7, TL-8, TL-9, TL-10, TL-101, TL-102,

TL-103 et TL-104. Prend en charge le code de sécurité avec 13 122 combinaisons différentes.

Incorpore des micro-interrupteurs de sélection de code, un indicateur LED et des bornes de connexion.

Emitter R.F. Industrial

Emetteur R. F. industriel

Emisor R.F. Industrial

Emissor R.F. Industrial

www.cebek.com

TL-15

Technical Characteristics

Voltage : 12VDC

Minimun consumption (without emitting) : 0 mA

Maximun consumption (emmitting) : 15 mA

Emission frequency :

Maximun reach : 100 mts.

Protection against polarity inversion (PIP) : Yes

Operating Indicator Led :

Sizes : 72 x 52 x 15 mm.

Weight : 25 gr

Din rail : C-7563

sat@cebek.com

433,92 Mhz

Yes

Page 1 For greater range and optimal performance you can use our Cebek C-0509 / C-0510 antennas. Émetteur à deux canaux compatible avec Cebek TL-1, TL-2, TL-3, TL-4, TL-7, TL-8, TL-9, TL-10, TL-101, TL-102, TL-103 et TL-104. Prend en charge le code de sécurité avec 13 122 combinaisons différentes.
Page 2 ANTENNE : Un câble rigide de 130 mm est fourni avec le circuit. , connectez-vous à la borne d'antenne marquée "Y". Pour une plus grande portée et des performances optimales, vous pouvez utiliser nos antennes Cebek C-0509 / C-0510. Emisor de dos canales compatibles con receptores Cebek TL-1, TL-2, TL-3, TL-4, TL-7, TL-8, TL-9, TL-10, TL-101, TL-102, TL-103 y TL-104 .
Page 3 TL-15 SECURITY CODE : First, the configuration of the security code must be carried out. All Cebek remote controls work on the approved frequency of 433.92 MHz. For this reason, they incorporate a row of 8 trinary dips, which allow you to configure a personalized security code for each control.
Page 4 TL-15 Important: do not activate TL 15 without antenna, it can damage the circuit Important : ne pas activer TL 15 sans antenne, cela peut endommager le circuit Importante : no activar TL 15 sin antena , puede dañar el circuito Important: no activar TL 15 sense antena, pot danyar el circuit www.cebek.com...