Publicité
Les langues disponibles
Les langues disponibles
NOTE: If fan or supply wires are different colors than indicated, have this unit installed by a qualified electrician.
1.
To set the code on receiver unit, slide dip switches
to the same positions as set on the remote. (Figure 1)
NOTE: The remote unit has 32 different code
combinations. To prevent possible interference from
or to other remote units, simply change the
combination code in the remote and receiver.
NOTE: Factory setting is all up. Do not use this
position.
WARNING
To avoid possible electrical shock, be sure electricity
is turned off at the main fuse box before wiring.
(Figure 2)
NOTE: If you are not sure if the outlet box is grounded,
contact a licensed electrician for advice, as it must be
grounded for safe operation.
CAUTION: INCORRECT WIRE CONNECTION
COULD DAMAGE THIS RECEIVER.
2.
Slide the receiver into the hanger bracket before
wiring as shown in figure 3.
3.
Connect wires using connectors as shown in
Figure 4.
WARNING
Check to see that all connections are tight, including
ground, and that no bare wire is visible at the wire
connectors. Do not operate fan until the blades are in
place. Noise and motor damage could result.
RECEIVER HARDWARE USED:
Wire Connectors
How to Wire Your Ceiling Fan
X
6
BLACK
L
WHITE
N
AC
POWER
Figure 4
Dip Switch
ON
1
2
Receiver
Unit
NOTE: Supply wires
omitted for clarity
GROUND
WELLOW
HANGER
/ GREEN
BRACKET
HANGER
BALL
Receiver
11
Receiver
3
4
5
Figure 1
Figure 2
Hanger Bracket
Dip Switch
Figure 3
RED
GRAY
YELLOW
DC MOTOR
BLACK
ANTENNA
Main Fuse Box
Publicité
