Foppapedretti Isofix i-Size FP360 Notice D'utilisation page 55

PRECAUTIONS TO MAKE SURE YOU HAVE CORRECTLY FASTENED THE CAR SEAT
HARNESS
IMPORTANT
For the safety of your child, always make sure that:
• The harness belts are correctly adjusted according to the
child's height, and are correctly tightened;
• The chest straps are adjusted in the correct position;
• The harness belts are not twisted;
• The tabs are properly engaged in the buckle
Rotate the seat into the forward-facing, and a click will indicate that it has locked in
place correctly (fig. 32).
CAUTION: Before travelling, make sure that the seat is locked in a forward-facing or
rearfacing position by trying to rotate the seat without pressing the rotation release
button.
REMOVING THE CAR SEAT FROM THE VEHICLE / REMOVING THE ISOFIX SYSTEM
At the same time press the ISOFIX release buttons and retract the ISOFIX connectors
(fig. 33). Remove the car seat from the vehicle.
Press the button (A) and lift up the support leg (1) until it locks (fig. 34A, 34B).
Fold up the support leg under the base (fig. 35,
REMOVING THE HARNESS (Storing the safety harness away)
• (Fig 37) - Completely loosen the shoulder straps, see paragraph "ADJUSTING THE
SEAT BELT (HARNESS) (Children from 40 cm to 105 cm / from 76 cm to 105 cm)".
• As shown in fig. 38A, release the locking strap of the chest protector from the metal
ring inside the shoulder strap.
• Remove the chest protectors by pulling them from the front of the car seat (fig. 38B).
• IMPORTANT: Do not detach the chest belts from the belt-tightening bracket.
• (Fig. 39) Pull the handle on the headrest and, keeping it pulled, raise or lower the
headrest, adjusting it according to the child's height.
• (Fig. 40) Press the red button on the central buckle to release the shoulder straps.
• (Fig. 41A, fig. 41B, fig. 41C) Unhook the press studs on the sides of the backrest
fabric, place the shoulder straps on the back of the fabric. Place the buckle tips on
• ENGLISH •
USE IN THE VEHICLE
36).
55