oventrop Regtronic S-Bus Notice D'installation Et D'utilisation page 14

5. DIP switches for relay allocation
Relay 1
Relay 4
Relay 7
Relay 10
Relay 13
Relay 16
| 14
The adjusted relay transmits information on pump speed
which is then converted into a corresponding signal. The
relay is selected by means of the DIP switches. Each relay is
characterised by a certain position of the switches.
Relay 1 is selected by default.
Î Put the DIP switches in the position appropriate for the
desired relay.
The following table shows the position of the DIP switches
for each relay,
Relay 2
Relay 5
Relay 8
Relay 11
Relay 14
During normal operation, the relay addressed will be dis-
played by the 7-segment-display. See chap. 6.2.
Relay 3
Relay 6
Relay 9
Relay 12
Relay 15