oventrop Regtronic S-Bus Notice D'installation Et D'utilisation page 13

2. connection
DIP switches for addressing the
signal output (see ch. 4.)
Jumper slot for the inversion of
the PWM signal (see ch. 3.)
8.
(1) (2) (3)
S-Bus terminals
Signal output
3. Adjusting the signal type
Jumper position for PWM signal
4. Inverting the PWM signal
Jumper not connected
100%
70%
30%
30%
The 0-10 V signal is not affected by the signal inversion.
Connection socket for
the mains adapter
(4) (5) (6)
Jumper slot for setting
the signal type (PWM
or 0-10 V; see ch. 6)
Jumper position for 0-10 V signal
Jumper connected
(factory setting)
PWM % 100%
ATTEnTIOn! Short circuit!
A short circuit can lead to damage to
electronic components!
Î Finish terminal connection and
close the housing before estab-
lishing the mains connection!
The interface adapter comes with a mains adapter for the
power supply.
The pump is to be connected to the signal output at the
terminals 5 and 6 (see table below).
The "S-Bus interface adapter" comes with a pre-connected
S-Bus cable. The second pair of S-Bus terminals can be used
for the connection of another S-Bus device.
S-Bus connection at the terminals:
S-Bus (1 + 2; 3 + 4) S-Bus input / output, either polarity
Pump connection at the terminals:
Signal output (5) PWM or 0 - 10 V
GND (6) Ground / Earth
The jumper to the right of the terminals is used for de-
termining whether a PWM signal or 0 - 10 V signal is to be
used.
The jumper poles are indicated with A, B and C.
Jumper position A+B = PWM signal (factory setting)
Jumper position B+C = 0-10-V-signal
Changing the signal type:
Î Pull the jumper out of the slot and insert it according to
the desired signal type.
Jumper slot for
the inversion of
the PWM signal
By means of the two-pole jumper slot to the left of the DIP
switches, the PWM signal generated can be inverted.
Changing the factory setting:
The minimum pump speed is 30 % (see figure to the left).
note
Whenever the pump is switched on, it will be
run at 100 % speed for a few seconds before
the flexible pump speed control is effected.
DIP switches for
addressing the
signal output
13 |