Velleman SOL10UC3 Mode D'emploi page 5

4. Overview
Refer to the illustrations on page 2 of this manual.
1 terminals solar panel
2 terminals battery
3 terminals load
4 USB output
5 mounting holes
5. Wiring
A photovoltaic panel
B fuse
Connect the components to the charge regulator in the sequence shown as
above. Pay attention to the positive and negative poles.
1. Connect the battery first. Check if the battery indicator turns green. If
not, refer to chapter Troubleshooting.
2. Next, connect the load, e.g. a lamp. The load should be DC applicant
with the same rated voltage as the battery's.
3. Finally, connect the solar panel.
V. 01 – 27/03/2017
SOL10UC3
6 setting button
7 battery status LEDs
8 load status LED
9 charging LED
C load
D battery
5 ©Velleman nv